Billet-specialties Billet Bolt-On Reservoir User Manual download pdf

500 Shawmut Avenue • La Grange, Illinois 60526 • Tech Line 708/588-0505 • Fax 708/588-7181

Rev. 11/12

Tools Needed;

1” open end wrench or adjustable wrench

1/2” open end wrench

1” deep socket

7/8” deep socket

1/4” allen wrench

9/64” allen wrench

Loc-Tite Blue Threadlocker

This kit ts the following applications;

-Small Block Chevrolet Tru Trac and V-Trac

-Big Block Chevrolet Tru Trac and V-Trac

P/N 77930/BLK77930 Power Steering Reservoir

Re-install the upper pressure nipple at this time.

Tighten rmly.

Install pump and reservoir onto the

Tru Trac or V Trac system bracket with

the 5/16”X3” allen bolts and loc washers.

Install power steering lines, ll system with

uid and bleed.

For pumps that have a RP1300 ow control

valve installed, install spring rst followed by

the plunger - screen side down before the

RP1300.

At this time remove the 5/16” installation nut

and discard. Set the 5/16” allen bolt aside for

later use.

Install the -6 AN nipple tting with o-ring into

the back cover and tighten rmly.

Place the reservoir back cover onto the reservoir.

Apply Blue Loc-Tite to the threads of the

ten 8-32 cap screws and install through

the cover and into reservoir.

Tighten rmly.

Starting at the top, install o-ring as shown

by pressing o-ring straight down directly

into groove.

Re-install o-ring if there is any additional

slack.

O-ring should seat into groove without any

extra length hanging out.

5/16 allen bolt supplied with Tru Trac or v Trac kit

Carefully place reservoir onto pump, thread the 5/16”

bolt through the reservoir and pump. Install the 5/16”

installation nut and nger tighten.

Thread the hex bolt with o-ring installed through

reservoir and into adapter tting on pump.

Tighten installation nut at this point.

Finish by rmly tightening hex bolt locking the

reservoir into place.

REMOVE

INSTALL

Remove the upper pressure nipple and set aside.

Remove the threaded supply nipple,

o-ring and washer.

Select the correct size threaded supply

nut. Install with o-ring and washer.

Tighten rmly.

For kits with the RP1300 ow control valve installed,

Remove the RP1300, plunger and spring. Set aside.

Rev. 11/12 1

Summary of Contents

Page 1 - Rev. 11/12

500 Shawmut Avenue • La Grange, Illinois 60526 • Tech Line 708/588-0505 • Fax 708/588-7181Rev. 11/12Tools Needed;1” open end wrench or adjustable wren

Comments to this Manuals

No comments

Billet-specialties Billet Bolt-On Reservoir User Manual

Browse online or download User Manual for For the car Billet-specialties Billet Bolt-On Reservoir. Billet Specialties Billet Bolt-On Reservoir User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Billet-specialties Billet Bolt-On Reservoir